Camera Module:
1.Support: 1080p/720p/640x480p video
2.Size: 25m*24*6mm
3.Fixed-focus lens, CSI interface
4.Static Picture Resolution: 2592x1944
5.Record Frequency: 30fps
6.CMOS Size: 1/4 inch
7.Aperture: 2.9
8.Focal Length: 3.29mm
9.Diagonal: 72.4 degree
10.Sensor Best Pixel: 1080p
11.Applications: for aerial photography, vehicle real-time photograph, indoor outdoor monitoring, take pictures, take videos
12.Notice: this product needs to match with infrared night vision lamp, then it can gain night vision effect; or it is only fixed-focus camera.

Screw Holes:
1.For fixing location
2.Self-equipped with power interface
3.Support 3.3V external power supply
4.Support connecting infrared lamp  

Hardware Connection:
1.Soft pin, 90 degree vertical connector beside the HDMI port. When connecting, one side of the contact comes toward HDMI interface.
2.Please remove the protection film before using it.
3.Please avoid the ESD harm.

Infrared Lamp Module:

3W high power infrared lamp (self-equipped with adjustable resistor and photoresistor, and it can achieve the
1W high power LED lamp operating or not according to the ambient light; and users can rotate the adjustable resistor
to adjust the ambient light and control 1W LED lamp operating).

Note: due to the limit of Raspberry Pi power, it will function well in the range of 1-2m. If the distance is too far,
the effect will be not very good.

Operating Principle:
Lock the LED lamp board and camera PCB board via the screw lock (Raspberry Pi doesn't need software to control.)
The operation way is when the brightness is dark, LED lamp will automatically start operating; when the brightness is bright,
the LED lamp will be automatically off. The premise is adjusting the adjustable resistor. it defaults not adjusted.

Notice: this infrared lamp is high power of 3W; when the Raspberry Pi connects 5V 2-2.5A power, peripheral devices
include mouse and keyboard; it connects camera and 2pcs 1W infrared lamp, Raspberry Pi and camera can work normally.
But after a long time of using, the power chip of Raspberry Pi and 2pcs 1W infrared lamp will give out heat.
So please pay attention to the heatsink problem, and users also need to take additaional device power consumption into consideration.